Next Phase Electric is a licensed and insured electrical contractor in Covington, WA, providing outlet and circuit installation across South King and Pierce County.
New outlets where you need them. Dedicated circuits for heavy appliances. GFCI for wet areas.
Book online
Enter your ZIP code. If we serve it, you pick the service and a time. It takes about a minute.
Simple swaps to new dedicated circuits.
Kitchen, bath, outdoor
Child-safe outlets
Outdoor rated covers
Arc-fault circuit interrupter
240V 30-amp
240V 50-amp
NEMA 14-50
240V for power tools
USB-A & USB-C built in
Fridge, microwave, AC
New install or replace
Add where you need them
Most callers spot one of these.
Older homes have one or two per room. We add outlets where you actually need them.
Heater or hair dryer trips the breaker? Circuit's overloaded. Dedicated circuit fixes it.
Remodels need new GFCIs, appliance circuits, and updated wiring to meet code.
EV, dryer, or range? Needs a 240V outlet on a dedicated circuit. Sized right the first time.
Decks, hot tubs, outdoor kitchens, holiday lights — weather-rated, GFCI-protected.
Sparking, warm, or loose outlets are a fire risk. We swap them and check the wiring.
A new heat pump or mini split needs its own power. We run it, mount the disconnect and pull the permit, on the same day your installer sets the unit if you like.
Sized from the nameplate on the outdoor unit, so the breaker and wire match what the heat pump or mini split asks for. No sharing with anything else.
A shutoff switch outdoors, within sight of the unit, so it can be powered down safely for service. The code asks for it, and inspectors check.
A weatherproof, GFCI-protected outlet near the outdoor unit, so whoever services it has power for tools.
A load calculation first. Backup heat in an air handler can need a large circuit of its own, and a full panel may need a subpanel.
Replacing an older unit? The existing circuit can often be reused when its size matches the new nameplate. We check before quoting.
Start to finish. No fuss.
Call or book online. Tell us what you need. We'll book the visit.
We check the location and panel capacity. Upfront price before any work.
Install, test voltage and ground, clean up. Most jobs done in one visit.
Looks simple — but bad wiring causes house fires. Every job to code.
Washington-licensed electricians. 15+ years, 2,500+ homes, background-checked crew.
Approve the price first. Surprise findings? We explain and ask before proceeding.
Shoe covers, drop cloths, clean exit.
Anything off, we make it right.
Adding an outlet means new wiring, which needs an electrical permit and inspection in Washington. We size the circuit, pull the permit, and make sure the outlet you add does not overload the one it is fed from.
In a living room or bedroom, the code keeps every point along the wall within 6 feet of an outlet, so outlets sit no more than about 12 feet apart. That rule covers new work. Older homes often have one or two per room, which is why cords end up across the floor.
Only as a short-term fix. The Electrical Safety Foundation calls power strips and extension cords temporary solutions and says never to chain them together. Space heaters should go straight into a wall outlet. If a room depends on strips every day, it needs more outlets.
The electrical code sets no fixed limit for general outlets in a home. What matters is what runs at the same time, so a room of lamps is fine, while one space heater can use most of a circuit. We check what is already on a circuit before extending it.
Usually, yes. We fish wires through existing walls and patch any small access points. Minimal mess.
Yes. A bathroom outlet has to be GFCI-protected and on a 20-amp circuit. If the bathroom already has a suitable circuit we extend it; if the only one is shared with other rooms, we run a new one so the hair dryer stops tripping it.
Yes. Garage outlets need GFCI protection. In a finished garage we fish cable inside the walls; in an unfinished one, conduit along the wall is quick and tidy. Freezers, compressors and chargers get their own circuit.
Yes, using a floor box made for it, with a cover that closes flat. It is easiest over a crawl space or an unfinished basement. A concrete slab needs a different approach, and we tell you which before pricing.
Yes, and that is the right way to hide the cord. A regular TV power cord should not run inside a wall, so a new outlet goes in the wall behind the TV. We usually fish the cable from a nearby circuit with little or no patching, and the plug stays hidden behind the screen.
Yes. Moving an outlet means running new cable, so it is treated like adding one and gets a permit and an inspection. The old box either comes out or gets a blank cover, and we tell you which before any work starts.
Yes, in spots where you charge every day, such as a kitchen counter, a nightstand or a desk. A USB-A and USB-C outlet fits in a regular box and still gives you the regular plugs. A laptop may charge more slowly than on its own charger, so check the wattage if that matters.
A circuit that serves only one appliance. Fridges, microwaves, dishwashers, and heaters should each have their own — no overloads, no trips.
Yes. WA code requires GFCI within 6 feet of water — kitchens, baths, laundry, garages, outdoors. Old outlets in these spots should be upgraded.
Yes. The dedicated 240-volt circuit, the outdoor disconnect, a service outlet nearby and the permit. We work alongside your installer, or wire a unit that is already set.
Yes. The electrical code calls for a shutoff switch within sight of the outdoor unit, so it can be powered down for service. We mount it on the wall by the unit.
Outlet swap: 30 min. New outlet on existing circuit: 1–2 hours. New dedicated circuit: 2–4 hours. Most jobs done in one visit.
Depends on whether we extend a circuit or run a new one, distance from panel, and outlet type. We give an exact price on-site before starting.
Next Phase Electric adds outlets and dedicated circuits in Auburn, Algona and nearby cities, from a bathroom outlet to a 240-volt circuit for a new appliance. We are licensed and insured. We check the location and the panel first, then give you the exact price before any work starts.
Book online or call. Installed quick, clean, to code.
Looking for one particular outlet or circuit? Each of these has its own page.
Kitchen, bath, garage, outdoor. Installed, replaced, or finally made to reset.
Ungrounded and two-prong outlets fixed the ways the code allows: a ground wire or GFCI protection.
NEMA 14-50, dryer, range, RV and welder outlets on their own circuit.
Remodel circuits, appliance power, garage outlets and shop 240V, permit pulled.
Dishwashers, garbage disposals and over-the-range microwaves replaced, wired and tested.
New and replacement openers, the ceiling outlet, sensors, keypads and the app set up.
Weatherproof GFCI outlets for the patio, deck, yard and driveway.
Dedicated 240-volt GFCI circuit and shutoff, wired before delivery day.
Sauna heater circuits, pool pumps and heaters, bonding and cold plunges, permit pulled.
Dead, loose, warm or worn outlet? That is the repair page.
Learn moreKitchen, bath, garage, outdoor — installed or finally made to reset.
Learn moreEvery small fault, one page.
Learn moreBreaker Replacement · Surge Protection · Smart Home Devices · Aluminum Wiring · All services
One specific job? 240V outlet installation · Outdoor outlet installation · Hot tub wiring · Subpanel installation